- Recording error cannot record on this disc after repairing how to#
- Recording error cannot record on this disc after repairing update#
- Recording error cannot record on this disc after repairing Pc#
Now we have to re-do the schedule settings one more time. Don’t forget to click Save to Apply (the erased) new settings. Sometimes these settings are done incorrectly or even messed up. Do it for the Continuous Mode, Event, Motion, etc. On this step, you need to erase all the settings already there, click the “Delete All” button, and erase everything. Once you see the successful format message, go to Configuration > Storage > Schedule Settings and then select the Record Schedule tab (as seen in the picture below). Keep in mind, always use a surveillance rated hard drive and reliable MicroSD cards. If you’re using a MicroSD card, ensure that it’s fully inserted in the slot and on the correct side. Inspect the unit carefully, make sure the wires are fully plugged in. Maybe the hard drive is dead (damaged) or is not hooked up properly, sometimes the MicroSD card may be loose. If you don’t see any hard drive or microSD listed there, it means the device is not detecting anything. Warning: any footage you may have there will be erased. This will format the whole hard disk space. You need to select the hard drive (or SD card) and click Format. There you should see listed any hard drive or microSD cards installed in the unit. Log into your recorder or camera and navigate to Configuration > Storage > Storage Management and select the HDD Management tab.
Recording error cannot record on this disc after repairing how to#
How to fix Hikvision Playback Failed (No Record Files) First by adjusting the recording settings and then by inspecting the hard drive and updating the firmware. In this guide, we will show step by step how to fix the Hikvision issue of playback failed or no record files. The issue is related to incorrect recording settings, corrupt hard drive (or microSD card), and, in some cases, glitches on the firmware. This message (“no record file”) shows up on an NVR, DVR, or on a single camera that has a microSD card. A not working playback defeats the whole purpose of your security system. It’s a frustrating issue that needs to be solved as soon as possible, otherwise, your security camera system won’t record anything. It means that the device cannot find any recordings on the microSD card or on the hard drive even though you can watch the cameras live.
Recording error cannot record on this disc after repairing update#
I found an update setting in the main menu tried it and it resolved the issue.You’re trying to playback the footage on your Hikvision device you get the message “No Record File” or “Playback Failed. I had a Sony Blu-ray DVD player awhile back that was very picky on what disks it would play. See if the DVD player has any updates available for it.
Please note that I have had a computer tell me that the disk is from the wrong region where a set top device just wont play the disk. My suggestion to find the cause is to try the non-functioning disks in another player or on computer with a DVD drive that is compatible with the disk.
Recording error cannot record on this disc after repairing Pc#
Many set-top DVD players use Laptop or PC sized drives with the same connections. I have had optical drive mechanisms spit lubricant and have left an oily film on the pick up unit causing this.īe very careful with this one as some units are mounted on very flimsy suspension/positioning mechanisms that will break if you look at them cross-eyed.Ī loose SATA or Data cable may be all that is stopping the information from the disk from getting to the circuit board. Many times it is just the disk is dirty scratched and the player cannot reliably read information from disk.ģ-Look for signs of lubricant/dirt on/under the player tray or on disk. If it seems to be speeding up and slowing down you could have a dirty/bad optical pick up assembly. I am afraid I am not familiar with the Samsung model in particular so I will give you a few general tips that may get you going.ġ- Make sure you hear the spindle motor spinning the disk to an even speed.